Hi,
I have some issues with my setup, this is the first time I'm using mikrotik, so not sure where to start.
My setup that I seem to have issues with is
on my CRS-326 running SwOS,
Port 1 is my incoming internet connection - I want all this traffic on VLAN2
Port 2-20 are access ports for PC's they should be untagged for VLAN5 and no other VLANs should go to them
Port SFP-SFPPLUS2 - hybrid port, untagged traffic should go to VLAN5, All other traffic should be tagged with VLAN appropriately (This port also contains my router, so it tags VLAN2 traffic as WAN)
Note; the PC setup works, I've been running the setup on an Aruba switch for a couple of years and is simply migrating the system to the MikroTik Switch.
so the problem:
Yesterday, I moved everything over and it seemed to be working. but sometime during the morning, the WAN port on the firewall would no longer get an IP and internet stopped working.
When looking at the traffic, there seemed to be some small amount of traffic to the internet (even though my firewall said there was not - and it had no IP)
At first I suspected my internet provider, but as soon as I moved the internet back to the old Switch it started working, when moved it back now it lost the IP. It could from time to time get an IP for 2-3 seconds, then it was cleared out again.
So my question here is - Did I setup the switch properly, so that any traffic that goes into Port1 get tagged with VLAN2 traffic and never get's untagged elsewhere?
anything else that someone can think of?
Link config (Port1 is currently not connected as I'm using internet through my other switch for now)
VLAN:
VLANs:
At first I tried this with routerOS, but had issues to get that setup, but if that is an better option, I would be happy to give that a try (I just didn't really understand the Bridge /interface concept there and how that interacted with VLAN's and addresses.)