I worked with this for 3 hours Friday, then for a couple more over the weekend and even asked an expert but the device is so new I can't find many who are using it yet.
I am running SWOS 1.2
This is a midpoint location where we are bringing in a backhaul on port 1 and sending it further down the line on port 2, something a plain switch can do. But I also want to do this:
1) Feed a backhaul into port 1
2) Have port 2 replicate that backhaul so it can be sent on down the line.
3) Get VLAN 450 data out on port 5, and of course feed untagged data from back into port 5 and have it go back out port 1 &2 on VLAN 450.
4) Get VLAN 9 data out on port 4, and of course feed untagged data from back into port 4 and have it go back out port 1 &2 on VLAN 9.
The backhaul is, I guess, considered a trunk and currently has several VLANs running on it.
The most I can get the 250GS to do is give me either nothing or VLAN1 out port 5.
I was following another thread that was very similar and I tried what was recommended there and it did not work.
I hope that as we get more familiar we can all contribute more examples such as this!
Thanks in advance!