I’ve an RB250GS and it is stuck in ACT LED fast flashing mode once power is applied to it rendering it totally unusable.
It was working well on SwOS 1.06 but the upgrade to 1.10 failed (no response after waiting for 15 minutes).
I’ve tried to push (& hold) the RESET button while powering up and release when ACT LED is flashing slowly (before it flashes quickly). Doesn’t work.
I’ve tried to reinstall SwOS by following the wiki guide below but there’s no response (0 hit). RB250GS' ether1 LED just flashes repeatedly (when connected to my RB750GL) but nothing happens :
http://wiki.mikrotik.com/wiki/SwOS#Rein ... S_firmware
Is there anything else I can do to reset the switch or bring it into some form of recovery mode ?