Hi,
I installed RouterOS x86 on my PC.
it is connected to internet by ether2
ether1 is connected to a switch.
when I monitor the ether2 interface, using webfig web page, I notice that there is always traffic,
even if I disconnect the switch (then, no computer connected to ether1, I display the web page because my mac is connected by wifi...
the traffic can be up to 200 kps
mot of the time, it is between 70kbps, to 50kbps
tx is always higher than rx. rx is between 50 to 20kbps.
any idea of why there is "so much" traffic ?
thanks