Community discussions

 
ik3umt
Member Candidate
Member Candidate
Topic Author
Posts: 248
Joined: Tue Jul 08, 2014 3:58 pm

Dynamic load balancing without PCC

Thu Oct 29, 2015 12:29 pm

Has anyone tried this ?

http://mum.mikrotik.com/presentations/US12/tomas.pdf

It uses traffic monitor to check used bandwidth and modify routing mark dynamically.

Any thought ??
 
User avatar
pukkita
Trainer
Trainer
Posts: 2984
Joined: Wed Dec 04, 2013 11:09 am
Location: Spain

Re: Dynamic load balancing without PCC

Thu Oct 29, 2015 1:10 pm

It's a good and greatly presented solution; you'll have to decide whether it suits your scenario or not.
Simplicity is the Ultimate Sophistication - Da Vinci
Getting the most out of this forum
 
UMarcus
Frequent Visitor
Frequent Visitor
Posts: 91
Joined: Wed Jan 21, 2015 10:11 am
Location: Europe

Re: Dynamic load balancing without PCC

Thu Oct 29, 2015 1:34 pm

It works as expected. I do my configuration based on that presentation to load balance between a DSL and SAT Line. Goal was that the high latency SAT line only jump in if the DSL line are full loaded (bandwith limit are reached). It works well. Additional i add NTH strategy if both lines are full loaded.

But actual i use 4 bonded DSL Lines. The SAT is part of the past now.

Regards
Marcus
 
ik3umt
Member Candidate
Member Candidate
Topic Author
Posts: 248
Joined: Tue Jul 08, 2014 3:58 pm

Re: Dynamic load balancing without PCC

Thu Oct 29, 2015 2:36 pm

Nice to hear it from you both
There are two scenarios I can apply to :

A company with 10-15 pc sharing three equal bandwidth dsl lines
A home network with a pair of pc and a pair of adsl lines

Which solution (PCC or traffic monitor) should I choose for each environment ??

Who is online

Users browsing this forum: No registered users and 92 guests