MikroTik

Hi All,

I am using RB3011 I have all my devices tagged with VLAN management ID 99, But there is one switch where the VLAN management ID is set to 1 as default and this can not be changed.
Rather then changing every device on my network to VLAN 1 is there any alternative? Is it possible to route VLAN 1 to 99 and 99 back to 1 via the MAC address for this device.
Its connected to trunk port 5?


Thanks

You can easily bridge different vlans together in ros.

You can easily bridge different vlans together in ros.

 Thanks I was going to try that later, so will I just add VLAN 1 to ros and add it to the management bridge which contains VLAN 99, currently I have ether2 port tagged as VLAN99 in the switch chip for port 2 and switch cpu, will I need to remove this?

I don't have experience with 3011 switch chip features. So just add vlans to the ports to get them to cpu and bridge them together.