If you want to see the traffic in torch, use "/interface bridge". You are using the "master-port" function which is different. Take a look at the diagrams in this wiki article: http://wiki.mikrotik.com/wiki/Manual:Sw ... _Switching
Using the "master-port" the traffic is processed directly in the switch chip, torch is done at the CPU, but using "master-port" packets dont get to the CPU.
Interesting! What steps are needed to set that up?But, when using Bridge, all ports share a single 1 gbps link to the CPU, so your layer 2 performance will suffer horribly. If you need to see all the traffic from a single port when using Master/slave port configuration, use port mirroring.
