My ISP uses a 2 Box setting : one is sending my DSL traffic to the WAN port (ether1) of my RB962, another gives me TV. Both boxes use a special protocol on Vlan100 (ethertype 0x0802), but I see only traffic on vlan100.
So I'd like to keep my setting for what arrives on native VLAN on port ether1, but bridge vlan100 on ether1 with vlan100 on ether5
What I did is :
Code: Select all
/interface vlan
add interface=ether1 name=ether1-TV vlan-id=100
add interface=ether5 name=trunk-TV vlan-id=100
/interface bridge
add mtu=1500 name=bridge-TV
/interface bridge port
add bridge=bridge-TV edge=yes interface=ether1-TV
add bridge=bridge-TV edge=no interface=trunk-TV
So what did I forget in my configuration ?
Thanks for any help.