I have been attempting to use the OpenVPN Client on the RB750Gr3, per this setup: https://support.hidemyass.com/hc/en-us/ ... ient-Setup
This works perfectly on a RB2011.
This works perfectly on a hAP Lite (RB941-2nD).
This does not work on a RB750Gr3.
* The OVPN Client establishes the tunnel and obtains an IP address.
* The OVPN tunnels tx/rx packets increment.
If I do a packet capture on the tunnel interface, I see the LAN client request and the responses from the internet hosts. But, the responses never make it back to the LAN client. The packet capture shows a huge amount of retransmissions and "spurious retransmissions" of packets within ms of each other, in Wireshark. It gives the appearance of packets looping and never exiting back out the LAN interface.
Has anybody else had success with this setup on this specific RB?
Is it possible the multi-core, multi-thread architecture of the RB750Gr3 is causing the issues???
I have tried this on 6.37.3 and 6.38.
Yes, I have disabled FastTrack, all my other mangle rules and queues, etc, etc.