We'd like to provide wireless AP service for a specific vlan. I can probably figure out the wireless stuff, but I'm having great difficulties getting the Ethernet switching sorted out.
We need Ethernet hookup to an existing Cisco switch trunk port with native vlan 1 for mangement to the OmniTik and vlan 12 for the wireless traffic. This is a fairly stright forward configuration on Cisco world, but I'm only finding bits and peices on RouterOS.
Below is what I've been able to gether so far, but it doesn't work (I lose access after the last command). Hints as to what I'm doing wrong to get a trunk with native vlan 1 and additional vlans going?
Code: Select all
/interface ethernet switch vlan
add ports=ether1,ether2,ether3,ether4,ether5,switch1-cpu switch=switch1 vlan-id=1
add ports=ether1,ether2,ether3,ether4,ether5 switch=switch1 vlan-id=12
/interface ethernet switch port
set switch1-cpu vlan-mode=secure vlan-header=leave-as-is
set ether1 vlan-mode=secure default-vlan-id=1
set ether2 vlan-mode=secure default-vlan-id=1
set ether3 vlan-mode=secure default-vlan-id=1
set ether4 vlan-mode=secure default-vlan-id=1
set ether5 vlan-mode=secure default-vlan-id=1
/interface vlan
add name=vlan1 vlan-id=1 interface=ether1
/ip address
add address=192.168.88.253/24 interface=vlan1 network=192.168.88.0
