I am hoping to get some assistance with an issue that I can't seem to figure out with regards to seeing one or two users active in the users list when I log into winbox as I am the only user to this router. I installed RouterOS version 6.35 and run the dude on an x86 server and whenever I log into via Mikrotik winbox and check the connections list in the firewall I see that I am connected however I then see the IP address of the router connected to itself (Source Port is different but the Destination Port is 8291). I followed some steps and did the following to tighten up the security however the results are the same:
/ip service disable 0,1,2,4,5,7
/tool bandwidth-server set enabled=no
/ip dns set allow-remote-requests=no
/ip socks set enabled=no
/ip ssh set strong-crypto=yes
tool mac-server set [find] disabled=yes
tool mac-server mac-winbox set [find] disabled=yes
tool mac-server ping set enabled=no
I even disabled the RoMON feature as we do not use it.
(/tool romon set enabled=no)
I've attached some images to show what it is that I'm seeing and I would greatly appreciate any assistance that can help direct me to resolving this issue. Thanks in advance to anyone that can assist.