I have an RB260GS and want it to operate like a L2 unmanaged switch.
I have 3 vlans passing on my network
Vlan8 192.168.88.0/24 (management)
I have an RB951 configured with IP 192.168.88.107
However when i connect to my RB1100 to see if i can see the RB951 through the RB260GS, it doesn't show the 107 IP address.
This is the network setup
RB1100 (eth5 config with all vlans enabled) - RB260GS eth1 - Eth 3 --> RB951 eth1 (also configured all vlans enabled)
I can see RB1100 and RB260 via WInbox with Ip address 88.x but can't see 88.107
If i plug RB951 direct to RB1100 I can see 88.107 in winbox.
Is there a missing config in RB260?