I have noticed, (see attached pic) sometimes the values on the interfaces in Winbox goes to "0" for a second and then back to normal. Happens every couple of seconds and from what I have seen, it has been happening since about 6.39, cant say if it happened before then.
Usually it happens after I did sniffing, or something like that on the Mikrotik device, this time it started doing it when I was connected to my router via Winbox and connected via VPN from my pc to one of my clients Mikrotik router
Ether1 is my WAN interface, I have +- 15 active users/devices on the network and does not "seem" to be impacting users
When I reboot the router, it goes back to normal again