Community discussions

MikroTik App
 
Azendale
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 50
Joined: Thu Feb 06, 2014 8:49 pm

How do you configure routerOS to respond to DHCPv6 requests for both addresses and Prefixes on the same interface?

Tue Apr 24, 2018 4:28 am

I think to do Prefix delegation, you just set a pool with a smaller prefix than the netmask on the block of addresses given to the prefix.

Usually, I would use RA messages to allocate WAN addresses on downstream routers, and then DHCPv6-PD to allocate prefixes for the LAN on those routers (and insert the route to those prefixes into the mikrotik).

But how do I do both at the same time? I need this because the DOCSIS (cable) spec apparently says no RA to configure the WAN of modems -- only DHCPv6. And you need DHCPv6-PD to hand off blocks of global address space. If I try putting two entries in for the same interface, it says that it is not allowed.

Who is online

Users browsing this forum: No registered users and 101 guests