Page 1 of 1
How to send traffic to the same gateway using a diferent ethernet port?
Posted: Fri Jun 22, 2018 3:18 am
by bajanetworks
Hello guys,
many years ago i did this but now I can not remember how to do it.
What I did before was:
IP > Routes
on the gateway field I put something like this: <IP-Address>~ether2 or <IP-Address>::ether2
Some one knows what is the correct syntax for this? also willing to know how to name this technique.
Thanks
Re: How to send traffic to the same gateway using a diferent ethernet port? [SOLVED]
Posted: Sat Jun 23, 2018 1:34 am
by Alancoma
That's easy
Gatewayip%etherX
Re: How to send traffic to the same gateway using a diferent ethernet port?
Posted: Sun Jun 24, 2018 9:28 pm
by bajanetworks
haaaa god!! the %
Thank you so much,
you say this is called 'east'? or you meant to say this was easy?
I dont understand you...
how can I find this on the router os documentation?
Re: How to send traffic to the same gateway using a diferent ethernet port?
Posted: Sun Jun 24, 2018 11:35 pm
by Alancoma
Sorry,
I wanted to say easy.
I found It on internet but I don't remeber where.
Re: How to send traffic to the same gateway using a diferent ethernet port?
Posted: Mon Jun 25, 2018 2:18 am
by Sob
I didn't find detailed description, but it is mentioned in manual:
gateway (IP | interface | IP%interface | IP@table[, IP | string, [..]]; Default: "")
Re: How to send traffic to the same gateway using a diferent ethernet port?
Posted: Fri Jun 29, 2018 2:58 am
by bajanetworks
thanks a lot guys,
I didn't find detailed description, but it is mentioned in manual:
gateway (IP | interface | IP%interface | IP@table[, IP | string, [..]]; Default: "")
where in the manual did you found it.
Re: How to send traffic to the same gateway using a diferent ethernet port?
Posted: Fri Jun 29, 2018 3:34 am
by chechito
thanks a lot guys,
I didn't find detailed description, but it is mentioned in manual:
gateway (IP | interface | IP%interface | IP@table[, IP | string, [..]]; Default: "")
where in the manual did you found it.
https://wiki.mikrotik.com/wiki/Manual:I ... properties