Page 1 of 1
I've closed all service ports by mistake
Posted: Thu Aug 16, 2018 2:08 pm
by virago
As the title said, I've closed all service ports by mistake on my SXTsq Lite5, so I've no longer have access to it to configure it. Is there any way to regain access - maybe throught serial port - in order to not to losse all the configuration by doing a factory reset?
Thanks!
Re: I've closed all service ports by mistake
Posted: Thu Aug 16, 2018 3:15 pm
by macgaiver
Yes, and there are no way to save config as disabled services are part of configuration.
https://wiki.mikrotik.com/wiki/Manual:Netinstall
Re: I've closed all service ports by mistake [SOLVED]
Posted: Thu Aug 16, 2018 3:20 pm
by nescafe2002
If you've only disabled the services listed under IP > Services, you should still be able to connect via MAC telnet and MAC winbox.
Re: I've closed all service ports by mistake
Posted: Thu Aug 16, 2018 3:22 pm
by k6ccc
Hopefully you have previously saved backups so after the net install, you can restore from your backup. If not, lesson learned - backup, backup, and off site backup.
Sent from a $&@#% iPhone using Tapatalk
Re: I've closed all service ports by mistake
Posted: Thu Aug 16, 2018 11:34 pm
by virago
This!
If you've only disabled the services listed under IP > Services, you should still be able to connect via MAC telnet and MAC winbox.
Thank you! You save my day!
