Community discussions

 
greg81x
just joined
Topic Author
Posts: 1
Joined: Sat Sep 01, 2018 11:20 am

Point point connection - SXT 5HnD and SXT 5nd r2 lite 5

Sat Sep 01, 2018 5:28 pm

Hey,
Due to the failure of one of the SXT 5HnD devices, I bought a spare SXT 5nd r2 for it.
In general, I have to create such a connection, it worked on the previous equipment, but I do not remember the settings at 100%.
A request to check the settings because I'm doing something wrong. Antennas connect with each other but I do not even see the antenna on the other side (no other devices too). In general, the configuration is in the attachment, but the connection is used to send the internet to the other network.
I will be grateful for your help ;)
You do not have the required permissions to view the files attached to this post.
 
User avatar
pukkita
Trainer
Trainer
Posts: 2982
Joined: Wed Dec 04, 2013 11:09 am
Location: Spain

Re: Point point connection - SXT 5HnD and SXT 5nd r2 lite 5

Sun Sep 02, 2018 11:47 am

Try this:

On the Station (SXT5 Lite r2):

1.- Go to Bridge.
2.- Remove unknown port
3.- Add wlan1 port to the bridge

Cannot say for sure as I'm missing some details about your config, but once you do that Layer 2 between both networks should be fixed, try pinging between any devices (but the antennas).

Fix the IP Addressing:

On Station:
1.- Edit 192.168.1.9/24 on wlan1 and change it to bridge1
2.- Remove 192.168.1.9/24 from ether1-local

On AP:
1.- Edit 192.168.1.8/24 on wlan1-gateway and change it to bridge1
2.- Remove 192.168.1.8/24 from ether1-local

Next time you can post the whole config of a routerboard (an export): open a New Terminal then issue
/export hide-sensitive=yes file=DeviceConfiguration.rsc
.rsc file being a plaintext file, you can inspect them with any file editor, post it here, etc.
Simplicity is the Ultimate Sophistication - Da Vinci
Getting the most out of this forum

Who is online

Users browsing this forum: kevinl and 48 guests