*RB450Gx4 configured using WebFig and QuickSet for default configuration
WAN interface is ether1
LAN interface is ether2 which is bridged for ether 2-5
IPv6 Installed configured for PD /60
Default IPv4 Firewall
Default IPv6 Firewall
Router: RB450Gx4 v6.4.27
Access Point: UniFi UAP-XG v3.9.42
Cable Modem: SurfBoard SB8200
Broadband Service: Comcast Gigabit Tier
Wireless clients connected to UAP-XG progressively slows down to half the the internet connection rate (500-600 mbps), whereas wired throughput remains consistent at ~930mbps. The wireless internet slow down can be replicated by running speed test (1st test 860mbps, 2nd test 720mbps, 3rd test 500-600mbps). Once throughput is degraded, wireless clients randomly experience extreme service degradation down to 15-25mbps.
Clean reboot of both router and access point restores wireless throughput to ~860mbps. Rebooting the access point only does not restore wireless throughput.
IP > Address default LAN address is set to ether2 instead of bridge0. Is this correct?
Interfaces ether 2 - 5 are in bridge and in the switch. How can I verify the interfaces are using the switch chip and not software bridging?
Thank you in advance. I'm new to MikroTik.