Hi i have mikrotik Wiless link that Uplink on 2 switch cisco
So i want Bridge link pass all VLAn on trunk
is work
My problem is Only see Radios Ap and Client On VLAN 1 Native VLAN
I want See Radios For example On vlan 100
And the Trunk Cross all VLan
If tage vlan 100 on WLAN interface Trunk Disconnect
Re: Wirless Managemnt On VLAN and Pass All vlans
Can you post a diagram?
-
-
raminmalek
Member Candidate
- Posts: 156
- Joined:
Re: Wirless Managemnt On VLAN and Pass All vlans
Hi Dear I post Visio For my toplogy
You do not have the required permissions to view the files attached to this post.
Re: Wirless Managemnt On VLAN and Pass All vlans [SOLVED]
So you already created a vlan interface.
Put this on the bridge, not on physical ports. Then add an appropriate ip address to that vlan interface.
Or enable vlan filtering on your bridges, create all allowed vlans for these and their tagged port mappings for both physiical interfaces (ether and wlan) and set your bridge pvid to your desired vlan (and adjust the IP address of course).
-Chris
Put this on the bridge, not on physical ports. Then add an appropriate ip address to that vlan interface.
Or enable vlan filtering on your bridges, create all allowed vlans for these and their tagged port mappings for both physiical interfaces (ether and wlan) and set your bridge pvid to your desired vlan (and adjust the IP address of course).
-Chris
Re: Wirless Managemnt On VLAN and Pass All vlans
Let see config of AP
/export hide-sensitive file=myapconfig
/export hide-sensitive file=myapconfig