Seems to be my new device then (o;
Great figures....well most higher bandwidth will be used for around 10 - 20 NNTP sessions....my cable provider just sent me a letter that they will upgrade the speed a tiny little bit to 600mbps...
IPsec is no high bandwidth demand as the remote sites have lower downstream speed as I have upload speed ( <= 30mbps ;o)
Just tested quickly ipfire on my APU2D4 box....can go up/down up to wire speed (1gig)...but what I don't like is that the system marks itself as unconnected when WAN side
is connected to a Cisco switch like WS-C3750E-24TD, where it takes a while until the switch sets the interface as up.....by then ipfire has continued with 169.254/16, eventually gets a new WAN IP, but it marked the system as unconnected beforehand
Not that I will use the 3750E on the WAN side in the end, was just for testing...but shows a design flaw in the boot process of ipfire...
hope RouterOS hasn't the same behavior during boot (o;