Hello,
I am using the new VLAN method when configuring an wAP ac. Setup is essentially same as the MikroTik router (which is working). I have mikrotik router with interface ports acting as trunk ports (vlan10 is untagged), and to downstream switches. Those switches are working. Also have older Ubiquiti Unifi AP's attached to those downstream switches with the same SSID's and vlans tagged and those are working... but the MikroTik wAP Ac is NOT. sad.
issue I'm having with the WAP, is the ether1 is untagged for vlan 10 (data), vlan-all-bridge is tagged. The primary vlan 10 (data), is working fine and clients connecting to this SSID are receiving IP address.
However, on the other SSID's I have - no DHCP address is coming through to the WAP. I have the PVID set on the wlan interface that is within /bridge ports
I will post config when I'm back onsite.. forgot to pull it down locally. But perhaps someone can make a suggestion as to why the tagged SSID interfaces are not being untagged within the bridge interface for DHCP to work?
Here is example of the config.. this is 100% off my memory of what I can remember:
/bridge name=all-vlan-bridge
/bridge ports
add port=ether1 pvid=10
add=wlan1 pvid=10
add=wlan2 pvid=20
add=wlan3 pvid=40
/bridge ports vlan
add=ether1 untagged tagged=all-vlan-bridge
add wlan1 untagged tagged=all-vlan-bridge
add wlan2 untagged tagged=all-vlan-bridge
add wlan3 untagged tagged=all-vlan-bridge
/bridge
interface=all-vlan-bridge vlan-filtering=yes
/interface vlan
add vlan=10 name=vlan10-data
add vlan=20 name=vlan20-guestwifi
add vlan=40 name=vlan40-control4
/ip dhcp client
interface=vlan10-data