Mikrotik > Juniper VLAN trunk
Posted: Sun May 12, 2019 12:18 am
I'm trying to pass 2 separate tagged VLAN traffic from a RB2011 (Ports 2-5 as VLAN id 10 for 192.168.44.0/24, and Ports 6-10 as VLAN id 20 for 172.16.44.0/24) through ether1 as a "trunk" without NAT (NAT handled by the Juniper later), though I guess VTP isn't supported. I've established a VLAN 20 that includes Ports 6-10 (which were already on a separate bridge), how do I get that traffic to ether1 along with VLAN 10 traffic from Ports 2-5? Here's what I have:
Which also means I'm not sure whether to configure the Juniper ge0/0/3.0 as a vlan trunk or access port, but that's probably a question for JunOS guys (leaning toward trunk), here's what I *think* I'll need on that end:
meanwhile I'm just trying to get the RB2011 to pass both VLAN 10 and 20 traffic to the Juniper over one Ethernet cable. Suggestions?
Which also means I'm not sure whether to configure the Juniper ge0/0/3.0 as a vlan trunk or access port, but that's probably a question for JunOS guys (leaning toward trunk), here's what I *think* I'll need on that end:
Code: Select all
vlans {
data44 {
vlan-id 10;
}
voice44 {
vlan-id 20;
}
}
ge-0/0/3 {
unit 0 {
family ethernet-switching {
port-mode trunk;
vlan {
members [ data44 voice44 ];
}
}
}
}