I have a problem. I have VLANs on my RB (RB3011UiAS). There is a working trunk port ether2 but I can't configure ether3 as an access port. There is a computer connected to that port unaware of VLANs and I need to have that computer in VLAN 30. According to Wiki https://wiki.mikrotik.com/wiki/Manual:S ... s_Ports.29 configuration should be like this, but it does not work. Am I missing something? Thank you very much for every suggestion...
Code: Select all
/interface bridge add name=bridge1 /interface bridge port add bridge=bridge1 interface=ether2 add bridge=bridge1 interface=ether3 add bridge=bridge1 interface=ether4 add bridge=bridge1 interface=ether5 /interface vlan add interface=bridge1 name=vlan20 vlan-id=20 add interface=bridge1 name=vlan30 vlan-id=30 /interface ethernet switch vlan add independent-learning=yes ports=ether2,switch1-cpu switch=switch1 vlan-id=20 add independent-learning=yes ports=ether2,ether3,switch1-cpu switch=switch1 vlan-id=30 /interface ethernet switch port set ether3 vlan-mode=secure vlan-header=always-strip default-vlan-id=30 /ip dhcp-server add address-pool=pool1 disabled=no interface=bridge1 name=server1 add address-pool=pool2 disabled=no interface=vlan20 name=server2 add address-pool=pool3 disabled=no interface=vlan30 name=server3
(This is shortened configuration. I configured IP addresses, pools, DHCP is working, trunk is working...)