How good/useful/dangerous is it to under clock RB4011 (down to 533MHz).
I use RB4011 mainly for the 10 x Geth + 5Ghz 4x4 Wifi it offers, but don't need all the CPU horse power it offers.
Now I saw the clock speed selection under ROUTERBOARD and started to reduce clock speed down to 533Mhz, hoping to safe also some power.
Two question arise:
- CPU load still shows same numbers as before, I wonder if load is measured relative to the full (normal) clock speed or relative to available MIPS (533M)?
- Any feedback / experience when using very low CPU frequency...? In theory you should only see worst case CPU being 100% if loaded, but you never know if there
are side effects...
Any feedback/knowledge out there?
Last but not least, anyone doing scripting based CPU frequency scaling???