i have a small issue, and i am having hard times finding a working solution for ..
My ISP service provider offers me 2 static IPs , split into 2 different blocks, meant to be used simultaneously on the same Mikrotik device.
Block 1 = 189.xxx.xx2.90/30
Block 2 = 201.xxx.xx9.124/30
Both IPs are sent on one single fiber connection directly from ISP provider to my mikrotik.
At the moment i am only using block1 , working fine, but now i have come to the needs of activating block2 , but on another mikrotik device on a different place..
Any ideas on how i can transport this block2 from my Main Mikrotik device to my second mikrotik device on a different location ?
Mikrotik1-ccr1009 receiving Block1 atm the moment working fine.
Mikrotik2-ccr1036 on a different location 20Miles awaw from Mikrotik1.
At the moment i have Fiber connection 10G sfp+ betwen Mikrotik1 and Mikrotik2 , and mikrotik1 is feeding Internet access to mikrotik2 , via Internal private LAN IP inside of a VLAN.
But now i have come to the needs of activating Block2 static public IP , directly on Mikrotik2-CCR1036, as i need to create direct DNS reverse zones for that Block2 static public IP , directly on Mikrotik2-CCR1036
i know i can create a bridge interface on Mikrotik1 and public both "block1 and block2" IP/addresses and assign on that Bridge Ports but would be only on Mikrotik1 (also the purpose of Bridge is to bridge physical and virtual interfaces) and not IP/addresses blocks on the same physical interface.
Any ideas or help is appreciated, as i am kind of lost on this one, and so far i have not seen a specific tópic with the same issue around here.