Hello,
I'm a bit confused about the proper way of configuring vlans on HAP AC2:
Here is what I want:
WAN => eth1
VLAN10 => ether2,4
VLAN100 => ether3
VLAN150 =>ether5
Ok, now here is the part that I don't get it
bridge menu : create bridge150=> assign ether5 to it
interfaces menu: create vlan150=> assign to interface bridge150
OR
interfaces menu: create vlan150 => assign to interface eth5 ?
++create the ip addresses + dhcp and assign to vlans .
Re: HAP AC2 vlans
Hm,
So, should I consider this setup as incorrect ?
Where ether5 is trunk port to a netgear SW (caring vlans10+100)
So, should I consider this setup as incorrect ?
Code: Select all
[admin@MikroTik] > /interface vlan print
Flags: X - disabled, R - running
# NAME MTU ARP VLAN-ID INTERFACE
0 vlan10 1500 proxy-arp 10 ether5
1 vlan100 1500 proxy-arp 100 ether5
[admin@MikroTik] > ip dhcp-server pr
Flags: D - dynamic, X - disabled, I - invalid
# NAME INTERFACE RELAY ADDRESS-POOL LEASE-TIME ADD-ARP
0 dhcp-default bridge default-dhcp 1h
1 I hotspot ap-guest hotspot_pool1 30m
2 I dhcp1 vlan10 pool_vlan10 1h
3 I dhcp2 vlan100 pool_vlan100 1h
Where ether5 is trunk port to a netgear SW (caring vlans10+100)
Re: HAP AC2 vlans
If you don't need those VLANs anywhere else than on ether5, nor you need to bridge ether5 with any other port, there's nothing wrong about that setup where the /interface vlan items are attached to ether5 directly.