vLAN 10 is defined in line 71 in ILikeU.rsc:
add bridge=Bridge1 [···] vlan-ids=10
The only one that is not already defined is vLAN 20 (But this is not the problem).
Line 71 and 75 u can see sfp3 and sfp4 configured as tagged/trunk ports on bridge1:
add bridge=Bridge1 tagged=sfp-sfpplus3,sfp-sfpplus4 [···]
add bridge=Bridge1 tagged=Bridge1,sfp-sfpplus3,sfp-sfpplus4 untagged=ether1 \
vlan-ids=99
That is the network Diagram: I'ts not the full diagram, because we can discuss for a year about it, but I only need to solve this particular problem.
Network.PNG
DHCP server are not in VLAN, the whole network is on layer 2 device with no VLAN capability. I defined 2 ports as access ports which are connected to L2 switches, then I tag the packets from this point to above. Right now access ports are working fine. The problem is the trunk ports, sfp-plus3 and sfp-plus4 are not trunking into cisco sg200 device. The problem which I mentioned days later was caused while importing the template.
You do not have the required permissions to view the files attached to this post.