Hey there,
i try to connect my hEX PoE RB960PGS to a switch via SFP, from where i am getting two VLANs: 42 untagged and 43 tagged (LACP Trunk). I have not configured the switch myself, that was done by my IT department, i just try myself to get the router connected (i need the router in a hardware project of mine).
I have done various configurations yet, e.g. https://tikdis.com/mikrotik-routeros/ne ... g/routing/ (text based) or https://www.youtube.com/watch?v=4G0nIklG9Pw (youtube), but no tutorial did work out for me yet.
Just to sum it up, these are the parameters i am getting from the switch:
VLAN 42 (untagged): IP 192.100.42.1/24, should be available on Eth2 Port without an IP Adress
VLAN 43 (tagged): IP 192.100.43.1/24, should be available on SFP Port with an IP Adress within the VLAN Range (e.g. 192.100.43.2); this VLAN is for Management only (snmp-request for a local prometheus server)
I am able to ping the gateway in VLAN 42 (which does not supprise me, since it is untagged). VLAN 43 gateway was not pingable till now. Any hints on that?