Community discussions

MikroTik App
 
Mike33
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 52
Joined: Tue Jun 25, 2013 2:13 am

Audience LTE6 kit - Unable to flash through the netinstall

Fri Apr 23, 2021 10:50 am

I do everything exactly according to this instruction - https://wiki.mikrotik.com/wiki/Manual:Netinstall.
An isolated network from a computer and a router.
I tried on two different computers.
I tried to connect the computer and the router both directly and through the switch.

The Audience starts successfully in Etherboot mode. The Netinstall sees the Audience.
I choose a RouterOS package - routeros-arm-6.48.2.npk.
I press the install button.
The Netinstall writes "Sending offer...".
After a short pause, everything is reset.
And the status of the router returns to "Ready".

Please tell me how to properly flash the Audience through the Netinstall.

model: RBD25GR-5HPacQD2HPnD
firmware-type: ipq4000
factory-firmware: 6.45.6
current-firmware: 6.48.2
upgrade-firmware: 6.48.2
netinstall: 6.48.2
 
Mike33
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 52
Joined: Tue Jun 25, 2013 2:13 am

Re: Audience LTE6 kit - Unable to flash through the netinstall  [SOLVED]

Sat Apr 24, 2021 3:29 am

Everything worked out! I managed to complete this quest.

Even though I disabled all unnecessary network adapters in Device Manager, netinstall still didn't work.

Netinstall worked after that:
- uninstalled VMWare (to remove VMWare virtual network adapters)
- uninstalled all OpenVPN virtual network adapters
- uninstalled old motherboard network card drivers
- updated to the latest version of the motherboard network card driver
- launched reset of Windows network settings:
netsh interface ipv4 reset
netsh interface tcp reset
netsh winsock reset

After these manipulations, Netinstall worked well and quickly.

Who is online

Users browsing this forum: h1ghrise and 93 guests