Good day All
Short version
I'm looking at doing away with all my bridges and wanting to go full routing but I'm at a loss. When creating a Route, you can only specify a single address or a range (which is defined by subnet, which is not ideal for closely spaced IPs). Is there a way you can predefine certain addresses the route can be applied to?
Longer version
I have multiple VPN connections settling on multiple bridges (my way of isolating certain segments of the network) but I would like to do away with the bridges so that broadcasts can be sent to specific points instead of being broadcast all over. I would imagine this not only being beneficial to "general" traffic but might also have with the SNMP requests being sent every few minutes (LibreNMS).
Any ideas/pointers/general direction?
Thanks,
R