They are connected like this: https://imgur.com/a/F0Le04M
My original network without the access point was discussed here: viewtopic.php?f=2&t=175973
It is now working fine. In the next step, I would like to add the second HAP AC2 device for two things: use it as a switch for vlan10 network, and also use it as a wireless access point later (CAP with multiple SSIDs on different vlans).
Here is my current config on the access point:
Code: Select all
/interface bridge
add name=BR1 protocol-mode=none
/interface ethernet
set [ find default-name=ether1 ] name=ether1-trunk
set [ find default-name=ether2 ] name=ether2-blue
set [ find default-name=ether3 ] name=ether3-blue
set [ find default-name=ether4 ] name=ether4-blue
set [ find default-name=ether5 ] name=ether5-blue
/interface vlan
add interface=BR1 name=BASE_VLAN vlan-id=99
/interface list
add name=VLAN
add name=BASE
/interface bridge port
add bridge=BR1 frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ether2-blue pvid=10
add bridge=BR1 frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ether3-blue pvid=10
add bridge=BR1 frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ether4-blue pvid=10
add bridge=BR1 frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ether5-blue pvid=10
add bridge=BR1 frame-types=admit-only-vlan-tagged ingress-filtering=yes interface=ether1-trunk
/ip neighbor discovery-settings
set discover-interface-list=!dynamic
/interface bridge vlan
add bridge=BR1 tagged=BR1,ether1-trunk untagged=ether2-blue,ether3-blue,ether4-blue vlan-ids=10
add bridge=BR1 tagged=BR1 vlan-ids=20
add bridge=BR1 tagged=BR1 vlan-ids=30
add bridge=BR1 tagged=BR1 vlan-ids=99
/interface list member
add interface=BASE_VLAN list=BASE
/ip address
add address=192.168.19.252/24 interface=BASE_VLAN network=192.168.19.0
/ip dns
set servers=192.168.19.254
/ip route
add distance=1 gateway=192.168.19.254 pref-src=192.168.19.252
/system identity
set name=caps01
But the access ports do not work. If I connect my laptop into one of the access ports of the switch, then I get an IP address from the DHCP server (running on the wan router). But if I connect to one of the access ports of the AP router (e.g. ether3-blue), then it does not work. Even if I type in an address/gateway/netmask manually, it does not work.
What am I doing wrong?