Good afternoon
we have a remote site, where for geographical reasons we arrive with radio links. for a question of capacity, 2 links were placed.
Side A, as seen in the graph, the radios are directly connected to the RB1036, where we create a Bonding in BALANCE mode rr.
Side B as it is in the graph, the Radios first reach a CRS317 switch, and each port is untagged in a vlan 100 and 110. Because from that CRS 317 there is a 10g link to a CCR1036.
In this we create a Bonding with the Vlan 100 and 110 in Balance rr mode.
This works!
But our problem is that we need to have management of the radios, but from each condo router we ping the radios we lose half of the packets, it is understandable because of the issue of (bonding rr) when we want it to be 802.3 nothing works. I understand that it may be because when in Router A We create the bondig errl CRS317 It listens and automatically creates the bonding, which would not be a problem, if I could put that bondig untagged in a vlan, and it will not be necessary to create the bonding in the router B.
any help. Thanks!!!!
En español:
Buenas tardes
tenemos un sitio remoto, donde por cuestiones geograficas llegamos con radios enlaces. por una cuestion de capacidad se colocaron 2 enlaces.
Lado A como se ve en el grafico los radios estan directamente conectados al RB1036, donde creamos un Bonding en Modo BALANCE rr.
Lado B como esta en el grafico los Radios primero llegan a un switch CRS317, y cada puerto esta untagged en una vlan 100 y 110. Por que desde ese CRS 317 va un link de 10g A un CCR1036.
En este creamos un Bonding con las Vlan 100 y 110 en modo Balance rr.
Esto funciona!
Per nuestro problema es que necesitamos tener administracion de los radios, pero desde cada router condo hacemos ping a los radios perdemos la mitad de los paquetes, es entendible por el tema de (bonding rr) cuando queremos que sea 802.3 no funciona nada. Entiendo que puede ser por que cuando en Router A Creamos el bondig errl CRS317 Escucha y crea automaticamente el bonding, lo cual no seria problema, si pudiera a ese bondig ponerlo untagged en una vlan, y no sera necesario ni crear el bonding en el router B.
cualquier ayuda. Gracias!!!!