We have the CCR1009-7G-1C-1S+ router/firewall/switch device.
I am performing the initial setup. My laptop is connected to ether1 - I do not have any sfp hardware so the 2 sfp ports are empty.
Interfaces side bar
Interface tab,
Traffic from my laptop to the MikroTik router makes the Tx and Rx counters on the Combo1 interface increment while it seems since I am physically plugged into the ether1 interface the Tx and Rx counters should be incrementing on the ether1 interface.
Is there any way to correct this as many of our administrators are remote and troubleshooting can always be not so fun with misleading details.
Thank you
Frank