I am trying to install a RB2011 as a leaf router.
I have enabled IPV6
The RB2011 does not see the main router, (all clients on same network DO see router)
When trying to configure:
[admin@MikroTikRB2011] /ipv6 nd>
.. -- go up to ipv6
add -- Create a new item
comment -- Set comment for items
disable -- Disable items
edit --
enable -- Enable items
export -- Print or save an export script that can be used to restore configuration
find -- Find items by value
get -- Gets value of item's property
prefix --
print -- Print values of item properties
remove -- Remove item
set -- Change item properties
[admin@MikroTikRB2011] /ipv6 nd>
The set command is invalid in this state. print works
the set command prompts
numbers:
rather than settable parameters. Where is the translation between "numbers" and actual parameters?
Confusing.....
Gullik