Hello,
Today I was configuring a new CRS354 48 Port switch following this guide: https://wiki.mikrotik.com/wiki/Manual:I ... s_Ports.29
I was connected to the switch via winbox using the mac-address. I added ethers 1-48 to the appropriate vlans. I setup one of the sfp ports as a trunk port. I had not yet configured an IP address for the device when I reached the point in the guide where it said to turn on vlan filtering. As soon as I turned on vlan filtering, I could not longer connect to the CRS324 through the mac address.
I see the switch has both a management port and a console port. Based on my research, it looks like I could get into the switch with the console port if I can track down a cisco console cable. Is there a way to get back into the switch using the management port, or via some other method besides the console port?
Thank you