Community discussions

MikroTik App
 
AndreKR
newbie
Topic Author
Posts: 27
Joined: Sat May 14, 2016 11:58 pm

Don't allow PPPoE out of the bridge

Wed Aug 04, 2021 2:37 am

Physically my setup looks like this:
           ┌──────┐      ether3┌────────┐
           │Switch├────────────┤750UP r2│
           └─┬──┬─┘            └──┬───┬─┘
             │  │                 │   │ether1
┌─────────┐  │  │                 │   │   ┌────┐
│DSL Modem├──┘  │                 │   └───┤PC 2│
└─────────┘     │                 │       └────┘
                │                 │ether2
     ┌────┐     │                 │       ┌────┐
     │PC 1├─────┘                 └───────┤PC 3│
     └────┘                               └────┘
I put ether1, 2 and 3 in a bridge and set this bridge as the interface for the PPPoE client. This works fine. Just for good measure I'd like to prevent PC 2 and 3 to make PPPoE connections. (Obviously nothing can be done about PC 1.)

I tried setting the interface of the PPPoE client to ether3 but then it says "Client is on slave interface".

Who is online

Users browsing this forum: rplant and 60 guests