I am trying to set up a redundant Router on a Stick network but I a problem on understanding how to implement this solution.
What I have is 2x Routers and 2x Switches(CRS3XX) and they are connected to each others as in the image in attachments.
The 2 switches have different VLANs and they communicate with each others with a router on a stick method.
Currently, I have set up the connection between SW1 and RT1 and everything works fine, VLANs can communicate, etc
What I did is:
Code: Select all
R1:
/interface vlan
add interface=eth2 name=VLAN10 vlan-id=10
add interface=eth2 name=VLAN20 vlan-id=20
/ip address
add address=X.X.X.X/XX interface=VLAN10 network=X.X.X.X
add address=Y.Y.Y.Y/YY interface=VLAN20 network=Y.Y.Y.Y
SW1:
/interface bridge
add mac=A:B:C auto-mac=no frame-types=admit-only-vlan-tagged ingress-filtering=yes name=bridge pvid=99 vlan-filtering=yes
/interface bridge port
add bridge=bridge frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ethX pvid=10
add bridge=bridge frame-types=admit-only-untagged-and-priority-tagged ingress-filtering=yes interface=ethY pvid=20
add bridge=bridge frame-types=admit-only-vlan-tagged ingress-filtering=yes interface=eth1
/interface bridge vlan
add bridge=bridge tagged=eth1 untagged=ethX vlan-ids=10
add bridge=bridge tagged=eth1 untagged=ethY vlan-ids=20
From my understanding, I should create a bridge and then put the 2 physical interfaces (eth2ð3) in it. After that I should be able to set the VLANs gateway IP to the bridge and switches should communicate with that.
Is there any settings that need to be applied to the bridge?
Anything that can point me in the right direction is well accepted.
Thanks for your time