Hello everyone

Here's the thing :

1. I have turned on hotspot on interface Local. The other interface is a backbone.

Behind that interface i have a usual AP, with address let say 10.10.0.10. I want it to make it accessible from the backbone side, and the MT itself. I don't need and NAT, all i need is to make hotspot pass packets for that ip, since it is an ap it can't authenticate itself. I saw a solve for this but that was for some previous RouterOS versions (i have 2.9).

2. To local interface a switch is plugged in and to it are plugged in two computers lets say 10.10.0.20 and 10.10.0.21. I want them to communicate with each other without being auth. (for some basic home networking like network printing etc.). I figured out that if i could make them communicate with each other i would just block other ips on MT from communicating to them. It's nonsense to make all packets between them pass through MT.

P.S If only turn off hotspot, backbone with no trouble can communicate that 10.10.0.10 device

To be

Anyone could help?
Thanks in advance

Michal

anyone ?? please??

I am facing the same problem. so if anybody could help pls.

DEAR gacopl :
i got it solved, if u are still having problem tell me and i will help u.

DEAR gacopl :
i got it solved, if u are still having problem tell me and i will help u.

anyway plz post the solution here: not for gacopl, but for the others =)

yes yes i need it i can't wait

Sorry for being late.
ok here is the solution that worked for me.
i use for my clients radios dlink dwl-2100
the range of i ips i use for them is 30.30.30.2-30.30.30.254
and for mikrotik ap's i use the range 40.40.40.2-40.40.40.254
what i did is i added the ip address 30.30.30.1 on the hotspot interface, then i went in winbox to tools ip scan, and i used hotspot interface and the range 30.30.30.0/24
after scanning i went to to hotspot host and searched relative ip adresses and made binding and instead of regular i did bypassed, ofcourse u should use the same ip of ur units instead of that given by the hotspot server, and after that all the units beacme pingable and could be accessed.
hope u got the idea and helped u in solving ur problem.
ready for any other help u need