Community discussions

MUM Europe 2020
 
User avatar
normis
MikroTik Support
MikroTik Support
Topic Author
Posts: 24317
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

RouterOS new manual topics

Fri Nov 28, 2008 2:06 pm

For those of you who are not following the WIKI changes, here are some new RouterOS guides:

http://wiki.mikrotik.com/wiki/Category:Manual

this will eventually turn into the RouterOS manual
No answer to your question? How to write posts
 
User avatar
jp
Long time Member
Long time Member
Posts: 599
Joined: Wed Mar 02, 2005 5:06 am
Location: Maine
Contact:

Re: RouterOS new manual topics

Fri Nov 28, 2008 3:34 pm

Looks to be a good improvement over previous documentation. Keep up that good work there.
 
User avatar
cmon69
Member Candidate
Member Candidate
Posts: 160
Joined: Sun Dec 10, 2006 2:23 am
Location: Waseca, Minnesota US
Contact:

Re: RouterOS new manual topics

Tue Apr 07, 2009 5:57 pm

Looking threw the new wiki I noticed the “R52 diagnose” is there any chance of this being expanded on! It would be nice to know what a persons meter should be set to. I couldn’t tell from the photo!
Christapher James Hasher
Waseca Wireless

Don't blame me, I didn't drink the cool-aide!
 
User avatar
cmon69
Member Candidate
Member Candidate
Posts: 160
Joined: Sun Dec 10, 2006 2:23 am
Location: Waseca, Minnesota US
Contact:

Re: RouterOS new manual topics

Fri Apr 10, 2009 7:16 am

Can someone please tell what type of meter is showen and what it set to?
Christapher James Hasher
Waseca Wireless

Don't blame me, I didn't drink the cool-aide!
 
dawam
Trainer
Trainer
Posts: 136
Joined: Wed May 31, 2006 1:40 pm
Location: Malaysia

Re: RouterOS new manual topics

Sat Apr 11, 2009 2:24 pm

from my electronic background the photo in the wiki is measuring whether connection is shorted ( low resistance value) or open high resistance. So any multimeter capable of measuring resistance can be used. Multimeter is set to measure resistance

The first photo - very low resistance (0.004 ohms - small value is measured, probably meter lead resistance ) or shorted connection between the two points. indicating a damaged .

2nd photo - high value resistance or open circuit.( .OL ) good radio, the 2 point is not shorted. the body of the radio is usually ground point.

The was some discussion in the forum where you could repair/replace the small component so that its not shorted anymore.
----------------------------------------------------------------
Everything looks complicated to begin with, but it's surprisingly simple when you understand it.

Who is online

Users browsing this forum: No registered users and 92 guests