Community discussions

 
wireless12
Member Candidate
Member Candidate
Topic Author
Posts: 295
Joined: Fri Aug 31, 2007 10:49 am

how to rest?

Wed Dec 17, 2008 9:40 am

hello frds..
how to reset both RB133C & RB133 for default factory settings not by using terminal command(software reset). but by hardware manually reset. if possible can i have the snapshot of all this stuff..

thx n regard
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24272
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: how to rest?

Wed Dec 17, 2008 9:46 am

Rb133 has a "reset" jumper next to the miniPCI slots. just close the jumper and boot, it will clear all config. don't forget to place the jumper back as it was
No answer to your question? How to write posts
 
wireless12
Member Candidate
Member Candidate
Topic Author
Posts: 295
Joined: Fri Aug 31, 2007 10:49 am

Re: how to rest?

Wed Dec 17, 2008 10:10 am

thx a lot @normis..i would be very nice of u if u could also provide me a snapshot..i dont wanna do any mistake, every piece of mikrotik i own is a treasure for me.i dont to loose a single of them.

thxxxxx
 
User avatar
normis
MikroTik Support
MikroTik Support
Posts: 24272
Joined: Fri May 28, 2004 11:04 am
Location: Riga, Latvia

Re: how to rest?

Wed Dec 17, 2008 10:21 am

reset_133.jpg
You do not have the required permissions to view the files attached to this post.
No answer to your question? How to write posts
 
gescriba
just joined
Posts: 1
Joined: Sun Sep 27, 2009 7:22 pm

Re: how to rest?

Sun Sep 27, 2009 7:36 pm

Hi,...
I read all the post about reseting 133c... but I can't do it in my 133c.
I understand perfectlyt the photo but i will explained the procedure that I have followed because I am sure I have to do it in a wrong way.

Routerboard is switch off....
I put the jumper in jp3
I switch on the routerboard
I wait until I listen first beep, and second and third beep
I switch off the routerboard
I take the jumper off
I switch on the routerboard

And I think that the 133c is reset but.. no!!!
Someone could help me please????

Who is online

Users browsing this forum: No registered users and 30 guests