I have 2 lobometrics radios which have 2 wireless cards.
I want to use one RF as TX and another as RX.
I think should do this with bonding interface, but I dont know how.
please help me figure it what should I do.

regards
alimoni...

you have to use Nstreme-dual to do this:
http://www.mikrotik.com/testdocs/ros/3. ... ent.php#.5

tnx normis, I`ll check it out, but I`m not familiar with configuring by console
I just have used winbox

may lobometrics radios are LOBO 968TS.

is it better to use one link for RX and another one for TX, or both of them in TX/RX mode but balancing the traffic?

I have no Idea what is lobometrics and what models they have, but I assume it uses RouterOS inside

yes, because I am using winbox for configuration.

http://www.lobometrics.com/968TS.htm

in winbox it's the same thing. just read the manual, and find similar options in winbox.

I linked first radio cards together and second cards together using station and bridge int mode.
then I changed the mode of all cards to nstrme-dual-slave.
then I created a Nstreme2 int and specified the cards for TX and RX,
as a remote MAC in Nstreme2 int I entered the remote TX radios MAC.

in a bridge I added ether1 and Nstreme2 int.

after I changed the radio modes to nstreme-dual-slave my links failed.
I know that I have critical problems in configuring Nstreme2 int , but I didnt findout what to do more than this by reading the link you gave me, give me a little hint please.

I did it with bonding but I couldn`t do it with Nstreme2.

with bonding ( using balance rr ) my throughput was about 80Mbps, according to http://www.lobometrics.com/968TS.htm it must reach up to 150 Mbps.
can Nstreme2 help me doing this or there is another way to reach this bandwidth ?

testing with winbox Bandwidth test in both way,
on TCP I got TX:40Mbps / RX:20Mbps
on UDP I got TX:40Mbps / RX:40Mbps

in one way transmission ( send or receive ) I got 60Mbps.

any idea?

Hi,

You can reach 150 Mbps in the better conditions. You should use turbo radios and nstreme2, in total 160 MHz of free 5GHz channel.



Regards,
Martín.

I can proof true +140 Mbps real throughput in a Lobo 968T. Use radios bonding, but not Nstreme2.

Can reach 150/160 Mbps with 968T with bonding two wireless, is not difficult. signal strength -60 and noise -98
With nstreme2 obtain 70/75 Mbps one path x2 = 140/150 Mbps.

I can proof true +140 Mbps real throughput in a Lobo 968T. Use radios bonding, but not Nstreme2.

Can reach 150/160 Mbps with 968T with bonding two wireless, is not difficult. signal strength -60 and noise -98
With nstreme2 obtain 70/75 Mbps one path x2 = 140/150 Mbps.

would you please tell me how to configure them? which type of bonding should I use?

I make a post long time ago here in the forum.. some other users help me with this, you have a picture too.


Regrds.

Contact with lobometrics or 34T technical support, they will help you to configure bonding and reach best results.