Hello.

Does anybody use bonding on high-speed links?

We tried to bond two gigabit links in balance-rr mode, and after 50-200 minutes of uptime with >600 Mbps traffic router goes crazy: ping - >50% packet loss, traffic ~ 1 Mbps on both NICs... Only reboot helps...

Router is connected to D-Link 3100-24TG switch.

I had a total failure bonding 2 WLAN of 2 RB433.
Maybe using EoIP through those phisical interfaces and bonding the EoIPs would work better.

i did it succefully, check below link

http://forum.mikrotik.com/viewtopic.php?f=2&t=26755

i did it succefully, check below link

http://forum.mikrotik.com/viewtopic.php?f=2&t=26755

what traffic bandwidth do you have over bonding?

p.s. 'broadcast' is failover mode. I need load-balance...