only one quistion untle know i dont have the answer for it

the quistion is :

my server have 4 ethernet port ...
every port have ip like that

ether1-----> for wan
ether2----->10.0.0.1/24
ether3----->20.0.0.1/24
ether4----->30.0.0.1/24

am connecting now from 10.0.0.1/24

i cant see my routerbord on ether3 >>> 20.0.0.1/24

how can from ether2 programing or entring my routerbord in another side ? ! !

how can i do that ?




dormador

Make sure that devices connected to your server has routes to reach other networks. Or at least add default route.

this is what happen when i want to contact the routerboard in another bridge

i thenk threre is a way to contact my router board if it is at another bridge when i make some roul in firwall

any idea


bad english i know
very sorry
but am do the best i can

regards

connect by IP, not by MAC

thanx very much Mr.Chupaka

put when am connecting whith ip

thats happen


any aidea please

this is my preparation

hmmm... can you at least ping that address before connecting to it?..

hmmm... can you at least ping that address before connecting to it?..

thanks very much Mr.Chupaka ...
am do like this to ending the problem ....
1- setup
2- R
3- Y


what can i do
i havent answer and my clints had unease...

am doing the default preparation....

bridge1
port
ether1
ether2
ether3
ether4

thanks for replying

regards