Community discussions

MikroTik App
just joined
Topic Author
Posts: 2
Joined: Mon May 23, 2005 6:48 am

conecting 5211 and 5213

Mon May 23, 2005 7:36 am

i used atheros 5211 with routerOS 2.8.11 and connect to atheros 5213 with routerOS 2.8.26
Using band 5 Ghz. The distance between those two radio are 7 km.
basic-rates-a/g=6Mbps,9Mbps for the two site.
When i used the bandwidth-test, i have total traffic up/down around 6Mbps.
The ping between those two are ok. Around 20 ms.
But the problem begin when i connect those two site with real traffic, which has traffic arround 4 Mbps. The ping are increase until 200 ms.
What is the problem ? It's only 4 Mbps traffic, still under 6 Mbps.
Posts: 28
Joined: Sun Sep 26, 2004 5:14 pm

Mon May 23, 2005 4:17 pm

I have the same problem conecting 5212 and 5211 on 2.5 Mbps have huge pings .
Very greatfull in a solution .
MikroTik Support
MikroTik Support
Posts: 505
Joined: Fri May 28, 2004 11:07 am

Mon May 23, 2005 5:41 pm

The basic rate is used for link maintenance -- set it back to 6Mb/s and then leave the supported rates to all of the rates.

Or reset the entire config and start ove.

Member Candidate
Member Candidate
Posts: 123
Joined: Fri Jun 04, 2004 8:19 pm
Location: Ráckeve

Mon May 23, 2005 7:10 pm

Set data rates max of 12 or 18mbps, and leave basic rates 6mbps as tully said. - the country you must visit

Who is online

Users browsing this forum: No registered users and 138 guests