Hi All
I recently switch over from m0nowall captive portal to mikrotik hotspot RB433 3.23. Her's my problem hopefully somebody can assist me or point me in the correct direction.
Freeradius worked correctly when a user has reached its volume limits and with the interim update of 1min it will disconnect the user on m0nowall. Working 100%
however
With Mikrotik the freeradius attributes ( Rate limit etc )works perfectly but it do not disconnect the user if its past the limits. If the user is pass the limit and you disconnect him manually, and try to login, mikrotik prevent the login which is correct. Interrum update has been set and can see its is working on the stats page in freeradius.
I tried the following:
1. Switch on incoming raduis on port 3779 on Mikrotik.
2. Nothing hapens when the user goes past, everything is 0 in the icoming radius stats page.
3. if I run the follwoing command mikrotik disconnect the user and I can see ACK = 1 in the stats page.
echo "User-Name=test,NAS-IP-Address=192.168.1.1,NAS-Port-Id=ether1,Framed-IP-Address=192.168.1.100" | radclient -q 192.168.1.1:3779 disconnect secret
4. Set Interrum Update in freeradius and in Mikrotik, still no go.
I see however in Freeradius 2.16 there is support fort originate-coa "Send-CoA-Request = No / Yes" do I need to upgrade.?
Does Mikrotik support Disconnect-Request like m0n0wall or is there something I am missing or can do in either Freeradius or Mikrotik to get the Disconnect-Request working, ether through a Disconnect-Request packet or CoA.
Thanks in advance.