SNMP service problem?

rastod · Wed Jul 06, 2005 12:09 am

Does SNMP service works on 2.9rc6 ? I am not able to read from MT any data. There was no problem on 2.8 .

changeip · Wed Jul 06, 2005 12:45 am

Working fine here ... at least for reading interface values. Not sure about other OIDs. My MRTG graphs are still reading in/out values for the different interfaces though.

Sam

rastod · Wed Jul 06, 2005 1:15 am

Yes, it works !!!

I am connected through PPPoE tunel to the MT and when trying to read SNMP from PPPoE connection, it does not work. When trying to read SNMP from "outer" network, it works. Is it possible?

changeip · Wed Jul 06, 2005 1:47 am

Does your input chain allow snmp access from pppoe interface?

Sam

rastod · Wed Jul 06, 2005 7:44 am

I have no filter defined on firewall

Wed Jul 06, 2005 10:19 pm

There is new feature in 2.9, "tool graphs".
It works similar

It is easier in configuring, and web checking also available, by router_ip/graphs.

rastod · Wed Jul 06, 2005 11:44 pm

it is not good solution. Why it does not work?

Thu Jul 07, 2005 12:00 am

Why it is bad ?

This thing should be tested.

changeip · Thu Jul 07, 2005 12:41 am

Is the interface you are querying a dynamic interface? You should always query a static interface / ip on the mikrotik for snmp - snmp service might not bind to changing ip addresses. Also, you might be able to setup a redirect rule to make it work, however querying the permanent interface address should work fine. It works here with no problems on rc6.

Sam

SNMP service problem?

SNMP service problem?

Who is online