Hi,
Been doing reading into this subject and have tried the following, as suggested in the wiki and other posts in the forums.
1. Flashfig utility does apply the config script selected, however when "/system default-configuration print" is called the original config (ether1 192.168.88.1 etc.) still shows.
2. Using netinstall reformats, partitions and installs the new ROS (routeros-mipsbe-4.11.npk) image and applies the config script selected, however the default config is still the original (ether1 192.168.88.1 etc.).
Question:
What would be required to replace the factory shipped default config with a script of my own? When "/system reset-configuration" is executed I want my new custom script to be executed.
Many thanks for your assistance.