Running on a new Rb711-5Hn-MMCX
5.0RC1 on both AP and client
I have ether1 and wlan1 bridged, one host connected to ether1 (tried a PC and a router - same results)
The host pops up in the bridge hosts list for a second and then goes away. Randomly appears again, then goes away. Device behind ether1 cannot pass traffic.
Downgrade to 4.11 - all works normally.
Anyone else seen this? I MAY have seen this on a 411 board as well today, but was unable to test enough to narrow the problem down.
-- Slightly off-topic: Will failed wireless connections from non-nv2 clients show up in the log if trying to connect to an nv2 AP?