Page 1 of 1

QoS for RB711

Posted: Thu Jan 27, 2011 9:14 am
by nsomlev
Can anyone recommend me a RouterOS version for RB711 with working WMM?
I've tested 4.10 to 4.16 and 5.0 up to rc5 without success so far. I've played also with NV2, but it is not an option since there is no stable release of 5.0 yet.
The configuration I'm using is simple bridge with some 802.1p CoS remarking. The traffic prioritization is not working whatsoever.

Thank you in advance.

Re: QoS for RB711

Posted: Thu Jan 27, 2011 1:52 pm
by prince90s
I recommend you use 3.30 or 4.16 version.they work is fine.

Re: QoS for RB711

Posted: Sat Jan 29, 2011 5:43 pm
by nsomlev
The QoS for 4.16 does not work.
I am not sure if 3.30 supports 802.11n radio.

Re: QoS for RB711

Posted: Sat Jan 29, 2011 6:31 pm
by prince90s
The QoS for 4.16 does not work.
I am not sure if 3.30 supports 802.11n radio.

The QoS for 3.20 does not work same.It looks Like to uninstall XEN components.

Re: QoS for RB711

Posted: Mon Feb 28, 2011 5:03 pm
by stalker802
I'm going to use this router, so i also need to know if it supports WMM?

Re: QoS for RB711

Posted: Mon Feb 28, 2011 5:44 pm
by stalker802
Do i need special license to configure this routerboard as access point?

Re: QoS for RB711

Posted: Mon Feb 28, 2011 6:46 pm
by marioclep
Do i need special license to configure this routerboard as access point?
RouterOS level 4 or above

Re: QoS for RB711

Posted: Mon Feb 28, 2011 10:03 pm
by stalker802
Found only wmm checkbox, i was hoping to find some advanced wmm configuration, time intervals and so on.