My 450G is fully operationnal with 4.17.
This are 3 problems that prevent my board to be operationnal on 5.0:
- cant modify switch-all-ports, answer is "mirror-source does not belong to switch", and "none" isnt recognized, so that if you define a valid interface there, you wont be able to "undo". Bugs not there on v4.17.
- pppoe-client (over a vlan on an ether1 non switched interface) isnt working anymore. I get this during past hour:
02:20:00 pppoe,ppp,info pppoe-fibre: initializing... 02:20:00 pppoe,ppp,info pppoe-fibre: dialing... 02:20:03 pppoe,ppp,info pppoe-fibre: terminating... - disconnected 02:20:03 pppoe,ppp,info pppoe-fibre: disconnected
- vlan secure mode is quite borked: vlan-id 0 has to be set, ok I've seen this on wiki, but the cpu port isn't recognized anymore as a valid port for declaring vlan 0:
It's not a problem unless you have a master port in your interfaces list... which is my case of course.
set ports=cpu numbers=0 port does not belong to switch
Even with cpu port declared (like when migrating from 4.17 where it was operationnal), ports concerned by master-port setup aren't operationnal.
What confirms that cpu port is involved and not taken in account is this:
interface ethernet switch host print Flags: D - dynamic, I - invalid # SWITCH MAC-ADDRESS PORTS TIMEOUT DROP MIRROR VLAN-ID 0 D switch1 3E:2D:A1:BC:94:DA ether3-LAN 2m30s no no 1 D switch1 00:0C:42:7F:40:75 (unknown) 2m no no
5.0 went stable, ahem...
Bug 1 was there since last RC (which was the first I tried back then).
I revert to v4.17.